Trailer Swap Chassis

Fliegl Tandem-Wechselanhänger TWP 180 Jumbo-ZL

Customized Transport Solution
Configure your Fliegl vehicle to meet your specific requirements. The vehicle shown is an example. Production and equipment are customized according to customer specifications.

*Chassis with swivel turntable
Fine-grained steel welded construction
Front stop, longitudinally adjustable and foldable
2 pairs of removable guide rollers, front and rear
1 pair of removable guide rollers, additional
4 container locks with sturdy 20"-based arms
for swap bodies 7.15 and 7.45
Swivel frame with heavy-duty ball bearing swivel ring
Wheel chocks with holder
Aluminum side impact protection
Side impact protection set inward for optimal clearance to the swap body supports
Steel underrun protection
Underrun protection shortened for optimal clearance to the swap body supports; lighting system mounted in a protected position
Rear mud flaps across the entire width (not compatible with forklift mount)
Quarter-shell front fenders and half-shell rear fenders
*Towing equipment for trailer turntable
Towing fork with certified 40 mm tow eye
Bedpfjzd Uvlsx Al Ujlp
Towing fork mechanically adjustable in length by approx. 6 x 100 mm (approx. 1900–2500 mm); towing fork length set to 2200 mm
*Axles + Suspension
BPW or SAF drum brake axles, at the manufacturer’s discretion
“Laser-aligned axles/chassis” to reduce tire wear and fuel consumption
Air suspension
*Brake System
2-line compressed air brake system
Color-coded piping for easy maintenance.
Air reservoir: 180 liters
Spring-loaded parking brake
2 non-reversible coupling heads at the front, with connecting lines to the tractor unit,
EBS, Electronic Brake System with EBS connector at the front, with connecting cable,
Caution: The trailer may only be towed by tractor units that ensure the effectiveness of the ABS!
With raise/lower valve, hold function in both lower and raise positions
Axle load detection via EBS CAN bus signal, for display in the cab; the truck must be equipped accordingly; no truck installation (no calibrated scale)
Tire pressure monitoring system
*Wheels and tires
235/75 R17.5, brand selected by the manufacturer
Steel rims in twin configuration, factory silver
*Electrical System
24 volts, Aspöck Eco LED II multi-chamber lights, yellow LED side lighting linked to the turn signals (“flashing side lights”), LED license plate lighting, (Note: With certain towing vehicles, false diagnostics may occur even though the system is functioning properly)
2 white LED front position lights
2 white/red rear lane-keeping lights (LED)
2 x 7-pin reverse-polarity-protected connectors at the front, with connecting cable,
LED work lights on both sides (activated by the reverse light)
2 additional LED work lights at the rear, activated by the reverse light
1 LED work light at the front, centered between the crossbars, shining toward the rear, activated by the reverse light
*Country of Registration/License Plates
Germany
with DEKRA approval and certification (in accordance with §13 EG - FGV)
24/7 service hotline
prepared for single-line license plate holders
Contour marking with reflective strips in accordance with ECE R 048, white on the sides and red at the rear
*Paint Finish
Frame hot-dip galvanized or painted according to customer preference